Siteworks Resectioning Arbitrary SPS930
791 بار بازدید -
9 ماه پیش
-
In this video, we will
In this video, we will demonstrate how to perform a resectioning survey using a Trimble SPS930 GNSS receiver and Trimble Siteworks software. Resectioning is a technique used to determine the position of a point by measuring its distance and direction from multiple known points. This technique is often used in construction and surveying to establish control points or to locate features that are difficult to access directly.
To perform a resectioning survey with a Trimble SPS930 and Siteworks, you will need the following equipment:
* Trimble SPS930 GNSS receiver
* Trimble Siteworks software
* A data collector
* A tripod and pole
* A prism
Once you have gathered your equipment, follow these steps to perform a resectioning survey:
1. Set up the SPS930 receiver on a tripod and pole at the point you want to resect.
2. Open Siteworks and create a new survey.
3. Select the "Resection" survey type and enter the coordinates of the known points you will be using to resect from.
4. Collect measurements to the known points.
5. Once you have collected measurements to all of the known points, Siteworks will calculate the position of the resection point.
You can then use the resected point as a control point for other surveys or to locate features that are difficult to access directly.
Here are some additional tips for performing a resectioning survey:
* Use at least three known points to ensure accurate results.
* Make sure that the known points are well-distributed around the resection point.
* Avoid using known points that are close together or in a line.
* Collect measurements to the known points in a clear and unobstructed area.
* If possible, collect measurements to the known points from the same height as the resection point.
If you have any questions about performing a resectioning survey with a Trimble SPS930 and Siteworks, please visit our website https://sitech-im.com
*Keywords:* Trimble SPS930, Siteworks, resectioning, GNSS, survey, control point, construction, surveying
To perform a resectioning survey with a Trimble SPS930 and Siteworks, you will need the following equipment:
* Trimble SPS930 GNSS receiver
* Trimble Siteworks software
* A data collector
* A tripod and pole
* A prism
Once you have gathered your equipment, follow these steps to perform a resectioning survey:
1. Set up the SPS930 receiver on a tripod and pole at the point you want to resect.
2. Open Siteworks and create a new survey.
3. Select the "Resection" survey type and enter the coordinates of the known points you will be using to resect from.
4. Collect measurements to the known points.
5. Once you have collected measurements to all of the known points, Siteworks will calculate the position of the resection point.
You can then use the resected point as a control point for other surveys or to locate features that are difficult to access directly.
Here are some additional tips for performing a resectioning survey:
* Use at least three known points to ensure accurate results.
* Make sure that the known points are well-distributed around the resection point.
* Avoid using known points that are close together or in a line.
* Collect measurements to the known points in a clear and unobstructed area.
* If possible, collect measurements to the known points from the same height as the resection point.
If you have any questions about performing a resectioning survey with a Trimble SPS930 and Siteworks, please visit our website https://sitech-im.com
*Keywords:* Trimble SPS930, Siteworks, resectioning, GNSS, survey, control point, construction, surveying
9 ماه پیش
در تاریخ 1402/07/06 منتشر شده
است.
791
بـار بازدید شده