DIY chamber vacuum sealer demo
20.7 هزار بار بازدید -
5 سال پیش
-
A quick demo of my
A quick demo of my homemade chamber vac sealer, its basically a diaphragm vac pump, the KNF Neuberger N022AN18 and a Vala KS 200 impulse sealer.
The sealer was bought new, then gutted and all the internals arranged inside my box.
I was poking the oring on the silicone seal bar to make sure it wasn't leaking, for those of you who were wondering what I was fiddling with halfway through.
The stainless steel roasting pan for the chamber was a bad idea, its only 0.7mm thick and flexes badly, Im busy with plan B at the moment, 8mm thick steel, 3mm x 50mm side walls and a cap strip of 5mm x 20mm for the seal surface.
The build was documented at Instructables.com, https://www.instructables.com/id/Buil... and this was basically to show the folks there how it works.
The sealer was bought new, then gutted and all the internals arranged inside my box.
I was poking the oring on the silicone seal bar to make sure it wasn't leaking, for those of you who were wondering what I was fiddling with halfway through.
The stainless steel roasting pan for the chamber was a bad idea, its only 0.7mm thick and flexes badly, Im busy with plan B at the moment, 8mm thick steel, 3mm x 50mm side walls and a cap strip of 5mm x 20mm for the seal surface.
The build was documented at Instructables.com, https://www.instructables.com/id/Buil... and this was basically to show the folks there how it works.
5 سال پیش
در تاریخ 1398/09/08 منتشر شده
است.
20,798
بـار بازدید شده