Solving Noise Issues When Using 2 Amps - Ask Zac 164

To Support the Channel: Patreon www.patreon.com/AskZac Tip jar: paypal.me/AskZac Venmo @AskZac Or check out my store for merch - www.askzac.com As soon as I got a second guitar amp in High School, I began experimenting with running both of them at the same time. In 1990 this usually meant a stereo chorus splitting the signal. An unwanted side-effect was that I found that my noise floor went way up, and sometimes, with certain pairings of amps, it seemed like my sound got smaller instead of bigger. It was not until almost two decades later, in 2002, I learned about the grounding and phase issues that have to be dealt with when running two amps simultaneously. Here, I show how to overcome these issues with an easy-to-find signal splitter that incorporates phase reversal controls, and safe ground lifting using an isolation transformer. Amazon link to Lehle P-Split III amzn.to/3MVoVU1 Book Nook Link - The Fender Archives, by Tom Wheeler amzn.to/42fyZfi The Stratocaster Chronicles, by Tom Wheeler amzn.to/3WANkBE Gear used: 1982 Kubicki body, 2022 Danocaster Neck, Glaser Convertible Bender, 80s Duncan middle, Ron Ellis 50/60 Tele pickup set. NYXL 9.5-44 Strings amzn.to/3qbGGpp 1965 Deluxe Reverb with 12" Eminence GA-SC64 speaker Link to 12" Eminence GA-SC64 speaker amzn.to/427wpYr 2023 Headstrong Lil' King with 12" Eminence GA-SC64 speaker headstrongamps.com/lil-king-amp Effects used: 1981 TC Chorus Mad Professor Deep Blue Delay Truetone CS6 power supply amzn.to/3WAMd4R #askzac #princetonreverb #telecaster