Building Halo Reach Spartan Armor - Legs

Hi all!
Thank you all for your patience on this! I've been working on this for the last few months with a few setbacks due to work with the busy summer. This video is a bit longer then my last ones but it will show my complete process in finishing the legs for my spartan armor from the beginning to the finished paint job. Feel free to ask any questions or any tips you'd like to share in the comments.  All items (or similar) that I bought for this will be listed below.

3D Printers I use - CR-10 V3 - https://amzn.to/3CcfxG2
Print Settings
-0.6mm nozzle
-3 layer walls
-15% density
-7% support density
-75 mm/s speed

Files for the Armor
- https://www.cgtrader.com/3d-print-mod...

Tools Used:
_____________________________________________

-Mens Tactical Military Suits Long Sleeve Rip-Stop Uniforms Combat Shirt and Pants - https://amzn.to/3Z7KwNP
-26FT Cable Straps 2 inch Wide with 20 Buckles - https://amzn.to/3Lltq9x
-Plastic Buckles 2 Inch - https://amzn.to/3KXn0gz
-Hook and Loop Tape 4in x 8in self Adhesive Sticky Back - https://amzn.to/3Peyhvk
-Super Fabric Adhesive - https://amzn.to/44HL1zj
-Milwaukee M12 Detail Sander - https://amzn.to/3I3uayY
-Filler Primer (Similar to the one I used in video) - https://amzn.to/3FYIExq  

Camera Gear:
_____________________________________________

Sony A7SIII - https://amzn.to/3WD8H4g
Sigma 24-70mm - https://amzn.to/3Gu5ezL  
Go Pro Hero 10 - https://amzn.to/3C2idFY

• #gaming
• #3d_print
• #halo
• #diy
• #cosplay
• #infinite
• #xbox
• #microsoft