How to Replace a Radiator In a 2000 Chevy Silverado
12.7 هزار بار بازدید -
3 سال پیش
-
First of all sorry the
First of all sorry the audio is so bad on this video. I just about scrapped the whole thing but decided to put a quick video together just incase it helps someone.
Second whenever you fill the radiator there is a procedure you should follow to make sure you don't have air in the system. you will fill the reservoir until it shows full. then turn the truck on. you will repeat this until the reservoir stays full after turning the truck on. At that point you turn the truck on until it gets up to operating temp. this allow the thermostat to open and runs coolant into the block. After it runs like this for a bit allow the truck to cool and check your coolant level again. Add coolant if necessary. Don't open your coolant tank while it is hot and pressurized!
Second whenever you fill the radiator there is a procedure you should follow to make sure you don't have air in the system. you will fill the reservoir until it shows full. then turn the truck on. you will repeat this until the reservoir stays full after turning the truck on. At that point you turn the truck on until it gets up to operating temp. this allow the thermostat to open and runs coolant into the block. After it runs like this for a bit allow the truck to cool and check your coolant level again. Add coolant if necessary. Don't open your coolant tank while it is hot and pressurized!
3 سال پیش
در تاریخ 1400/06/03 منتشر شده
است.
12,749
بـار بازدید شده