200 Year old lathe headstock repair...
18.2 هزار بار بازدید -
2 هفته پیش
-
I'm restoring a headstock for
I'm restoring a headstock for a vintage Ornamental Turning lathe circa 1820. I need to cut a very unusual thread to make some locking nuts and bring this old machine back into service. in this video I talk you though the challenges I face and how I solve them.
The Society of Ornamental Turners;
https://www.the-sot.org/
Support the channel;
https://www.patreon.com/joneseymakes
Buy project plans, 3D printable items and merch!
https://www.joneseymakes.com/
Check me out on instagram;
https://www.instagram.com/joneseymakes/
Timestamps
https://www.seevid.ir/fa/w/7h-R_vheMSk Introduction
https://www.seevid.ir/fa/w/7h-R_vheMSk The problem at hand
https://www.seevid.ir/fa/w/7h-R_vheMSk An oddball thread
https://www.seevid.ir/fa/w/7h-R_vheMSk Making the locking nuts
https://www.seevid.ir/fa/w/7h-R_vheMSk Thread cutting
https://www.seevid.ir/fa/w/7h-R_vheMSk Milling the flats
https://www.seevid.ir/fa/w/7h-R_vheMSk Shop made vice stop
https://www.seevid.ir/fa/w/7h-R_vheMSk Finishing the nuts
https://www.seevid.ir/fa/w/7h-R_vheMSk Parting off
https://www.seevid.ir/fa/w/7h-R_vheMSk Locking nuts complete
https://www.seevid.ir/fa/w/7h-R_vheMSk The completed lathe
https://www.seevid.ir/fa/w/7h-R_vheMSk Using a treadle lathe
https://www.seevid.ir/fa/w/7h-R_vheMSk Ornamental Turning
2 هفته پیش
در تاریخ 1403/06/16 منتشر شده
است.
18,253
بـار بازدید شده