PianoDisc: Low Profile Installation

Full-length video of PianoDisc's Low Profile Installation Instructions
Download the PDF instructions: http://bit.ly/RuOvkp

Jump to specific chapters by clicking the times below:
00:07:45 - 02 - Remove the keybed
00:15:42 - 03 - Measure for key access
00:26:15 - 04 - Measuring for keyframe cut
00:31:00 - 05 - Create backrail bead on keyframe if required
00:32:48 - 06 - Cut the keyframe
00:34:50 - 07 - Mark the location for the solenoid slot
00:41:38 - 08 - Prepare to cut the solenoid slot
00:42:59 - 09 - Cut the solenoid slot
00:47:50 - 10 - Reinforce the keybed
00:48:39 - 11 - Cut leg tops to clear the solenoid slot
00:51:25 - 12 - Assemble the tray, solenoid rails, and guide solenoids.
00:55:48 - 13 - Installing the trapwork
01:23:06 - 14 - Adjusting the key solenoid plungers
01:25:49 - 15 - Install key solenoids
01:28:56 - 16 - Assemble driver boards to the solenoid tray
01:31:34 - 17 - Setup for burn in
01:33:27 - 18 - Burn in the unit
01:33:53 - 19 - Install driver boards into the tray assembly
01:36:54 - 20 - Drill hole in the belly rail for wires
01:37:47 - 21 - Mount the CPU
01:38:27 - 22 - Mount the power supply
01:40:10 - 23 - Mount the power strip
01:41:48 - 24 - Installing keybed to the piano
01:42:32 - 26 - Set the height of the adjustable plungers
01:45:08 - 27 - Set up communication with the PianoDisc system
01:46:17 - 28 - Adjust the pedal solenoid
01:51:21 - 29 - Final check list
01:52:38 - 30 - Ground strap installation
01:53:42 - Addendum 1 - Steinway sostenuto
01:57:20 - Addendum 2 - Keyframe modifications / Shift lever
01:57:38 - Addendum 3 - Clearance for end plates

• #music
• #pianodisc
• #low_profile_installation