FIXED! DJI Phantom 4 Pro Remote Control Battery Charge Issue [Disassembly, Repair, Reassembly]
108.5 هزار بار بازدید -
7 سال پیش
-
Links to tools featured in
Links to tools featured in this video:
Heat gun/reflow station (updated version): https://amzn.to/3wttDmb
Not featured in video, but used during the repair:
Helping Hand stand: https://amzn.to/3wCy1Q0
Voltmeter: https://amzn.to/3P5GrWy
Extra reflow solder (not needed in my repair, but some may need it if there is too little solder left to reflow): https://amzn.to/3P1FKgR
Some links are affiliate links. As an Amazon Associate, I earn from qualifying purchases.
UPDATE! : A viewer using this method had good results using a higher reflow temperature (350° C) for shorter time and helpfully suggests using thermal tape to protect plastic pieces! See the comments section.
For a look at performing the actual reflow, check out Mark Dean’s video: P4 controller not charging - reflow
ORIGINAL DESCRIPTION: This video describes a possible fix to the DJI Phantom 4 Pro controller failing to charge or show an accurate battery charge. By reflowing key connecting points on the controller's circuit board, I was able to restore full functionality.
Did this technique work for you? Please leave any comments or questions in the comments area!
Mentioned in this video:
DJI message boards post by Rainer1: https://forum.dji.com/thread-116313-1...
Videos by Robson Raul (Portuguese language): @rrdrones
Please note that this technique may involve risk and should only be attempted if your device is unable to be repaired by a professional technician. Any attempted repair is done at your own risk!
Heat gun/reflow station (updated version): https://amzn.to/3wttDmb
Not featured in video, but used during the repair:
Helping Hand stand: https://amzn.to/3wCy1Q0
Voltmeter: https://amzn.to/3P5GrWy
Extra reflow solder (not needed in my repair, but some may need it if there is too little solder left to reflow): https://amzn.to/3P1FKgR
Some links are affiliate links. As an Amazon Associate, I earn from qualifying purchases.
UPDATE! : A viewer using this method had good results using a higher reflow temperature (350° C) for shorter time and helpfully suggests using thermal tape to protect plastic pieces! See the comments section.
For a look at performing the actual reflow, check out Mark Dean’s video: P4 controller not charging - reflow
ORIGINAL DESCRIPTION: This video describes a possible fix to the DJI Phantom 4 Pro controller failing to charge or show an accurate battery charge. By reflowing key connecting points on the controller's circuit board, I was able to restore full functionality.
Did this technique work for you? Please leave any comments or questions in the comments area!
Mentioned in this video:
DJI message boards post by Rainer1: https://forum.dji.com/thread-116313-1...
Videos by Robson Raul (Portuguese language): @rrdrones
Please note that this technique may involve risk and should only be attempted if your device is unable to be repaired by a professional technician. Any attempted repair is done at your own risk!
7 سال پیش
در تاریخ 1396/10/08 منتشر شده
است.
108,511
بـار بازدید شده