How to PROPERLY wire up a key ignition switch for ATS and ETS2
45.6 هزار بار بازدید -
4 سال پیش
-
Wiring isn't obviously final, just
Wiring isn't obviously final, just quickly wired it up for demonstration before I put it on my rig.
** Take note you can actually run this wiring with only two plugs. You don't need to connect up the accessories to the board.
So two white wires to the battery, a blue wire to Ignition, and a blue wire to Start. Then you still keep the jumper between ignition and accesorries**
Ignition Switch Used:
https://www.amazon.ca/Dorman-85936-Co...
USB Encoder:
https://www.amazon.com/Easyget-Contro...
** Take note you can actually run this wiring with only two plugs. You don't need to connect up the accessories to the board.
So two white wires to the battery, a blue wire to Ignition, and a blue wire to Start. Then you still keep the jumper between ignition and accesorries**
Ignition Switch Used:
https://www.amazon.ca/Dorman-85936-Co...
USB Encoder:
https://www.amazon.com/Easyget-Contro...
4 سال پیش
در تاریخ 1399/03/05 منتشر شده
است.
45,652
بـار بازدید شده