Metal Casting at Home Part 64. Casting and Machining a Toothed Pulley.
5.4 میلیون بار بازدید -
8 سال پیش
-
The video shows how a
The video shows how a toothed pulley was cast and then machined.
The pulley is to go on my spin indexer which will be connected with a toothed belt drive to an Arduino controlled stepper motor.
This will enable any number of divisions to be indexed at the touch of a button.
The electronics and Arduino sketch were devised by Gary liming and can be seen here. http://liming.org/millindex/
Details were also given in Model Engineers workshop issue 249.
Arduino and LCD shield https://goo.gl/s7R4Zz
Motor driver https://goo.gl/Fh72ie
Stepper motor
https://www.omc-stepperonline.com/nem...
The pulley is to go on my spin indexer which will be connected with a toothed belt drive to an Arduino controlled stepper motor.
This will enable any number of divisions to be indexed at the touch of a button.
The electronics and Arduino sketch were devised by Gary liming and can be seen here. http://liming.org/millindex/
Details were also given in Model Engineers workshop issue 249.
Arduino and LCD shield https://goo.gl/s7R4Zz
Motor driver https://goo.gl/Fh72ie
Stepper motor
https://www.omc-stepperonline.com/nem...
8 سال پیش
در تاریخ 1395/10/26 منتشر شده
است.
5,415,474
بـار بازدید شده