OpenBuilds C-beam Machine new build Plate
3.4 هزار بار بازدید -
9 سال پیش
-
This was the first project
This was the first project that I had made on this machine since the included build plate would not give me a full 12in x12in build area I scaled the plate down and used a thicker piece of aluminum to clear the rear stepper motor as well.
The first half of this video I did not record, but due to the cam methods that I used it took hours to do a few holes. I canceled the job and changed cam strategies so that It would complete the job much faster. This video is sped up 4 time but was around 15 minutes or so not sped up
The first half of this video I did not record, but due to the cam methods that I used it took hours to do a few holes. I canceled the job and changed cam strategies so that It would complete the job much faster. This video is sped up 4 time but was around 15 minutes or so not sped up
9 سال پیش
در تاریخ 1394/11/03 منتشر شده
است.
3,403
بـار بازدید شده