"Stupid Strong" CNC Build - PART 5 - THE FIRST CUTS!
162 بار بازدید -
6 سال پیش
-
How to build a DIY
How to build a DIY CNC machine completely from scratch. I designed the machine in Fusion 360 from the ground up and had a local water jet cut the parts.
The frame is built from 1/2" aluminum plate. Fully supported linear rails reduce the flex and NEMA 23 stepper motors drive the anti-backlash ball screws for the best possible performance on a budget. I used a TinyG motor controller in this project.
In this episode I tidy up the wires and make our first cuts!
++Learn Fusion 360 For Hobbyists and
6 سال پیش
در تاریخ 1397/01/06 منتشر شده
است.
162
بـار بازدید شده